Name: OSMO | UV Protection Oil Tints Natural with Film Protection Red Cedar Satin 428 2.5l
SKU: 390982

Very water and dirt resistant
Reduces wood swelling and shrinkage
Resists growth of algae, mildew and fungal
Microporous, breathable finish which does not crack, peel, flake or blister
No sanding necessary for future applications

Surface Preparation

Wood surface must be clean, dry and frost-free (moisture content max. 20%)
UV-Protection-Oil Tints is ready to use
Do not thin
Stir well using a flat stirring stick or spatula before use
Ideally, surfaces are sanded no finer than a P120 grit grade of sandpaper
Sanding to finer grades will reduce required absorbency
If possible, and if the wood is absorbent, please apply first coat to all sides before installation
Fresh wood containing natural wood ingredients /extractives (eg: Cedar, Teak, Mahogany or Iroko) are often less absorbent and need to weather off first before applying the product
Please refer to website ‘Suitability’ section for more details
Weathering helps ingredient rich wood become more absorbent and the wood finish adheres optimally
For renovation works, clean old microporous stains thoroughly – if necessary sand lightly
Clean and restore already greyed or weathered wood at the same time with Osmo Wood Reviver Power-Gel
Old paints and lacquers must be completely removed
As a general rule, wear a dust mask during sanding works
To maintain absorbency, avoid sanding surfaces finer than a P120 grit
Weather ingredient rich wood after sanding
The finished surface is influenced by several factors, including the condition of the wood
Therefore, a trial application is always required, especially for unfamiliar surfaces.
Softwood species like Pine or Spruce are more prone to blue stain, rot and insects
If desired, pre-treat these soft woods if possible on all sides with Osmo WR Base Coat

Method of Application

With Osmo Flat Brush or Osmo Microfibre Roller, apply thinly along the wood grain and spread well
Allow to dry for approx. 12 hours under good ventilation
Then apply the second coat
Alternatively the second coat can also be carried out with UV-Protection-Oil Extra Clear
When recoating colour treated surfaces, or for renovation works, one coat applied to the clean and dry surface is usually sufficient

Care

Regular Cleaning: Damp cleaning with Osmo Spray-Cleaner
Occasional Maintenance: If necessary, intensive cleaning and refreshing using Osmo Wood Reviver Power Gel or Osmo Gard Clean
Recoating: Simply re-apply one coat onto the clean and dry surface when signs of wear become visible